Skip to main content ↑ ↓
Topic: iptables logs (Read 924 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

iptables logs

I am trying to troubleshoot setting up a firewall and need to log some iptables output.

I have done:
Code: [Select]
$ sudo iptables -A INPUT -j LOG

and then looked around in my /var/log, even searching with:
Code: [Select]
$ sudo find /var/log -mmin 1

but cannot find it.

Can you help me figure out where iptables LOGs are going, and if nessisary how to specify a location?

Using Artix with runit.

Re: iptables logs

Reply #1 –
Quote from: pshaw – on
I am trying to troubleshoot setting up a firewall and need to log some iptables output.

I have done:
Code: [Select]
$ sudo iptables -A INPUT -j LOG

and then looked around in my /var/log, even searching with:
Code: [Select]
$ sudo find /var/log -mmin 1

but cannot find it.

Can you help me figure out where iptables LOGs are going, and if nessisary how to specify a location?

Using Artix with runit.

until your firewall is running there won't be an iptables log

basic firewall is gufw.  sudo pacman -S gufw ufw ufw-runit  then start ufw.  now you got some /var/log/iptables.log
Cat Herders of Linux

Re: iptables logs

Reply #2 –
I know that iptables is the firewall built into the kernel.  I'd rather use it.  I have rules established in /etc/iptables/iptables.rules

On the Arch wiki it says logging is handled by systemd.  If we aren't using systemd we have to use a secondary program?

I also know that iptables is running since it is blocking traffic.  I just need to find the logs.

Code: [Select]
$ sudo sv status iptables

run:  iptables: (pid 2043)  45183s

Re: iptables logs

Reply #3 –
My question is really:  Arch uses systemd to handle iptables logging.  How does Artix do this?

Re: iptables logs

Reply #5 –
yep, installed and running.  no log/run though so... maybe i can add that manually?  I'll investigate
 

Re: iptables logs

Reply #6 –
Quote from: pshaw – on
yep, installed and running.  no log/run though so... maybe i can add that manually?  I'll investigate
You probably need to up the iptables --log-level .Default seems to be 'warning'.
I just played around with setting
Code: [Select]
iptables -A INPUT -j LOG --log-level debug
and also
Code: [Select]
iptables -A INPUT -j LOG --log-level debug --log-prefix "[IPTABLES] "
And then blocking all traffic. Whole bunch of entries in /var/log/everything.log but also, as a surprise to me, /var/log/iptables.log was created with the same entries.

I do not remember ever doing anything special to get an separate iptables log file but I may have done and forgotten.
Doubt it though /etc/syslog-ng/syslog-ng.conf contains
Code: [Select]
destination d_iptables { file("/var/log/iptables.log"); };

So you probably need to up the level to debug or info to see what you wish and where the logs end up will depend on how / what handles your logging and how it's setup.