I am on a Dell Vostro 15 3530 laptop.
When I installed Artix , display properties only show one available resolution (1920x1080).
When I installed Arch however, display properties show the full range of resolutions.
GPU is Intel Raptor Lake-P [UHD Graphics].
What is missing in the Artix install?
Can I really not use Artix on my computer?
I'm no expert in this matter
maybe you missing a package, like `xf86-video-intel`
I'm sure I'm missing something, but not xf86-video-intel, that's in my package list.
Thanks for the reply though.
Just for info, on an Intel PC, I have these packages installed:
libva-intel-driver
libvpl
vulkan-intel
Thanks for the reply.
I have all three of those in my package list as well.
hello again
have you consulted this wiki article for troubleshooting?
https://wiki.archlinux.org/title/Intel_graphics
Miracle of miracles....I updated my system today (pacman -Syu)and something in the update fixed my problem.
After six months of trying everything I could, someone out there updated their software and saved me.
I can finally go back to using Artix...my favorite distro! Bless you software updaters.
And thank you to everyone who tried to help me here too.
How do I mark this solved?
Just to put a final cap on this subject.......
Today's update (4-5-2024) put me back to square one....only one resolution listed.
Checking the pacman log I see "xf86-video-intel" was updated.
And sure enough the update that set things right (4-2-2024) also included "xf86-video-intel".
So I deleted it, rebooted, and all is right again.
We'll see where this goes I guess.
Read this manual (https://wiki.archlinux.org/title/Intel_graphics#Installation). You should delete xf86-video-intel.
Thank you. I'm learning....always learning.
it helps but honestly, this is not the kind of thing worth learning. 5 years from now it will be ancient history. These are the kind of things that you hope just works.