I'm not sure if the question fits in here since I'm running Artix inside a VM.
Host is Manjaro Linux.
For whatever reason the NAT connection is lost.
This time even creating a my VM again from scratch is no longer working.
An e1000e connection does work.
On guest:
ip addr on guest
virt-manager connection in xml
<interface type="network">
<mac address="52:54:00:8d:cd:66"/>
<source network="default" portid="94cebc1a-2b7b-41ba-91a4-22958fe3aef4" bridge="virbr0"/>
<target dev="vnet4"/>
<model type="virtio"/>
<alias name="net0"/>
<address type="pci" domain="0x0000" bus="0x01" slot="0x00" function="0x0"/>
</interface>
On host:
ip addr on host
$ ip addr
...
4: virbr0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
link/ether 52:54:00:8c:9c:74 brd ff:ff:ff:ff:ff:ff
inet 192.168.122.1/24 brd 192.168.122.255 scope global virbr0
valid_lft forever preferred_lft forever
9: vnet4: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master virbr0 state UNKNOWN group default qlen 1000
link/ether fe:54:00:8d:cd:66 brd ff:ff:ff:ff:ff:ff
inet6 fe80::fc54:ff:fe8d:cd66/64 scope link proto kernel_ll
valid_lft forever preferred_lft forever
sudo virsh net-dumpxml default
<network connections="1">
<name>default</name>
<uuid>b728bff2-6215-4472-8d38-a5a797d328aa</uuid>
<forward mode="nat">
<nat>
<port start="1024" end="65535"/>
</nat>
</forward>
<bridge name="virbr0" stp="on" delay="0"/>
<mac address="52:54:00:8c:9c:74"/>
<ip address="192.168.122.1" netmask="255.255.255.0">
<dhcp>
<range start="192.168.122.2" end="192.168.122.254"/>
</dhcp>
</ip>
</network>
Topic: Running Artix in a VM. Can't get virtio NAT connection. (libvirt/virt-manager) (Read 264 times)
previous topic - next topic