Skip to main content ↑ ↓
Topic solved
This topic has been marked as solved and requires no further attention.
Topic: [SOLVED] Setting networking on a newly installed headless vps (Read 582 times) previous topic - next topic
0 Members and 2 Guests are viewing this topic.

[SOLVED] Setting networking on a newly installed headless vps

I try to install artix_s6 iso in a headless remote vps.
I am past the installation of the base system and i try to set networking.
I follow artix installation instructions but
i dont think they explain how to configure my eth0 interface.
There is no /etc/network/interfaces file.

Re: Setting networking on a newly installed headless vps

Reply #1 –
Did you also install conman as per our wiki and started the service?

Re: Setting networking on a newly installed headless vps

Reply #2 –
I missed that..  :-\

Re: Setting networking on a newly installed headless vps

Reply #3 –
No problem, but prior to posting here, make sure that you have accomplished all the steps needed for any task.

Re: Setting networking on a newly installed headless vps

Reply #4 –
Quote from: linuxer – on
No problem, but prior to posting here, make sure that you have accomplished all the steps needed for any task.

Sorry,. In the future i will be sure prior to posting here for any issues i have that i will have accomplished all the steps needed for any task.